Chemical protective clothing can not be cleaned and disinfected by taking it at will. Before cleaning and disinfection, the final cleaning and disinfection scheme shall be determined based on the comprehensive analysis of the material and parameters of the chemical protective clothing, the type, concentration, contact time and other factors of the chemical protective clothing.
If the cleaning and disinfection of chemical protective clothing are not standardized, there will also be the risk of secondary pollution. Therefore, Huatong fire protection introduces the mechanical cleaning and disinfection methods of chemical protective clothing to ensure the normal use of chemical protective clothing and personal safety of users.
1. Remove the antifogging mirror, ventilation device and D-ring, clean and disinfect them separately, and then wash them thoroughly with clean water (if there is no such accessories, this step can be omitted).
2. Take out the backpack mat and clean it separately with warm water.
3. Remove the exhaust valve protective cover and the old valve gasket.
4. Clean the valve gasket separately with warm water, and then disinfect it.
5. Fully open the zipper of chemical protective clothing.
6. Spread the chemical protective clothing on the clean workbench and smooth the wrinkles.
7. Insert the support washer into the head cover, so that the mirror is close to the support washer and coincides with the support washer.
8. Pull the laundry bag onto the top of the hood so that the foam material of the laundry bag is placed on the surface mirror, and the edge of the laundry bag is located above the lower edge of the face mirror. Tighten the rope and tie the knot.
9. Roll up the socks or chemical boots twice. Avoid sharp fold points.
10. Place the sleeve in the middle of the chest. Smooth out wrinkles.
11. Fold the head cover with the laundry bag and the upper part of the chemical protective clothing so that the face mirror is placed on the rolled up chemical protective boots. Smooth out wrinkles. Pay attention that the mirror shall not be deformed.
12. Put chemical protective clothing into industrial washing machine
13. Start the "chemical protective clothing" washing procedure. Note: water temperature: 62 ℃± 2 ℃, 4 times of rinsing process.
14. Dry all parts
